No products in the cart.
The Newpowa Double Arm Single Pole/Wall Side Mount NPB-100P is designed to mount a single Newpowa 60W-100W rigid solar panels (but can be easily adapted to other brands and sizes).
The REDARC 40A Fuse Kit is equipped with high-quality fuses and fuse holders to fit the cable required for the specified current and make a solid connection. This ensures your installation is working safely and efficiently. Poor quality fuse holders typically don’t make enough contact with the fuse, which allows dirt and other elements to get in between contact points. This generates excess heat, which can be enough to melt both the fuse and the holder.
The REDARC 60A Fuse Kit is equipped with top quality fuses and fuse holders to fit the cable necessary for the specified current and make a solid connection. This provides a safe and efficient installation. A common problem customers often face is the use of poor quality fuse holders. When a fuse holder doesn’t make the right contact with a fuse, there is room for dirt and dust to affect the contact points. As a result, excess heat is generated which can melt both the fuse and the holder.Prevent fuse problems with a REDARC Fuse Kit. The kit is offered in a 40A version as well and both are designed for BCDC installations. The REDARC 100A version is designed for SBI installations. Each fuse kit comes with (2) fuse holders, (4) 40A fuses, cable crimps, and a detailed instruction sheet.
The remote on-off eliminates the need for a high current switch in the input wiring. The remote on-off can be operated with a low power switch or by for example the engine run/stop switch (see manual).
500A Base-Mount Shunt with 333A operating current and .10(m) resistance at 50mV.
The APD Is an “Alternator Protection Device” that works when the spike back voltage to the alternator shoots above 16.5V -> infinity (potentially) as the current has gone to 0A (to conserve P = I x V).
The Cyrix Battery Combiner is a microprocessor controlled heavy duty relay that automatically connects batteries in parallel when one of them has reached a pre-set voltage (indicating that the battery is being charged), and disconnects when the voltage decreases below float level (indicating that one or more batteries are being discharged). Cyrix Battery Combiners are an excellent replacement for diode isolators. The main feature is that there is virtually no voltage loss so that the output voltage of alternators or battery chargers does not need to be increased.
This control interfaces with the Victron range of MPPT Charge Controllers and gives access to performance information. It can also be used to program the charge controller. A VE Direct cable (not included) is required to make the connection to the MPPT controller. The MPPT Control lets you see the status and setup all MPPTs that use a VE.Direct communications port. The new MPPT Control is mounted in the same housing as the BMV energy monitor
The Victron Phoenix Inverter Control works with Phoenix Inverters equipped with a UTP monitor and control socket. It can also be used with a MultiPlus Inverter/Charger when no charger function is needed.
This Optional Remote part # BBURC works only with the following part #’s