Uncategorized
-
$78.20
Victron MPPT Control
This control interfaces with the Victron range of MPPT Charge Controllers and gives access to performance information. It can also be used to program the charge controller. A VE Direct cable (not included) is required to make the connection to the MPPT controller. The MPPT Control lets you see the status and setup all MPPTs that use a VE.Direct communications port. The new MPPT Control is mounted in the same housing as the BMV energy monitor
-
$844.05
Victron SmartSolar MPPT 250/85-Tr VE.Can
At Battle Born Batteries, we use only the best products and components to ensure you get the best system for our lithium deep cycle batteries.
-
$638.35
Victron SmartSolar MPPT 250/60-Tr
At Battle Born Batteries, we use only the best products and components to ensure you get the best system for our lithium deep cycle batteries.
-
$102.85
Victron GX Tank 140″
The GX Tank 140 connects to the Cerbo GX by USB and takes readings from up to four tank level sensors. The Cerbo GX has a built-in interface for four resistive tank senders. The GX Tank 140 inputs are for voltage based or current based senders only. Tank levels can be read-out locally in the system, as well as remotely through the VRM Portal.
-
$245.65
Victron GX-LTE-4G
The GX LTE 4G is a cellular modem for our GX range of monitoring products. It provides a mobile internet connection for the system and connection to the VRM Portal. It works on 2G, 3G and 4G networks.
-
$15.30
Victron GX Touch 50 Wall Mount
The GX Touch wall mount accessory allows easy mounting of the GX Touch 50 on a solid wall. No drilling or cut-out is required, other than the three screws that fix the wall mount onto the wall.
-
$736.10
Victron SmartSolar MPPT 250/70-Tr
At Battle Born Batteries, we use only the best products and components to ensure you get the best system for our lithium deep cycle batteries.
-
$226.95
Victron Orion-Tr Smart Non-isolated 24/12-30A
The Victron Orion-Tr Smart DC-DC charger is a DC to DC adaptive 3-stage charger with built-in Bluetooth. This device can be used in dual battery systems in vehicles or on boats where the alternator and the start battery are used to charge your house batteries. The unit can be monitored and programmed via Bluetooth and can be remotely controlled via a remote on/off switch. The Orion-Tr Smart charger can be used in 12V or 24V systems. Models are available up to 400W and unlimited multiple units can be connected in parallel to increase output power!
-
$67.15
Victron Orion-Tr Isolated 24/24V-5A
Remote on-off
The remote on-off eliminates the need for a high current switch in the input wiring. The remote on-off can be operated with a low power switch or by for example the engine run/stop switch (see manual). -
$75.65
Victron Cyrix-Li-ct 12/24V-120A Intell. Li-ion Batt. Combiner
The Cyrix Battery Combiner is a microprocessor controlled heavy duty relay that automatically connects batteries in parallel when one of them has reached a pre-set voltage (indicating that the battery is being charged), and disconnects when the voltage decreases below float level (indicating that one or more batteries are being discharged). Cyrix Battery Combiners are an excellent replacement for diode isolators. The main feature is that there is virtually no voltage loss so that the output voltage of alternators or battery chargers does not need to be increased.
-
$29.95
.3M Thermister WS500 AT-K
0.3-meter replacement Alternator Temperature Sensor kit. Can also be used as short length ATS.
-
$49.95
8M Thermistor WS500 LT-K
Long length (8-meter) Temperature Sensor Kit. May be used for either Alternator or Battery Temperature Sensor.
-
$19.95
RJ45 Cover Caps
Cover Caps to provide additional protection for the WS500 RJ45 external jacks. (Sold in pairs)
-
$24.95
Waterproof RJ45 Cable Ends
Waterproof Connectors to provide a sealed connection to the WS500 Regulator’s external CANbus connectors. Cable ends for use with Cat5e or Cat6 data cables.
